Monday, September 5, 2016

Fiberglassing the vaka (6)

Six hours of work between friday and sunday. We tilted the main hull (vaka) on a side to facilitate draping and subsequent wetting out of the fiberglass. However we first had to get rid of several epoxy drips and fair the deck and bottom fg edges.


We then wet out and simultaneously cut to size the fiberglass, using more than one kg of clear resin


Last evening we went to check everything and discovered a big (3 cm diameter) air bubble exactly on the side panel  butt joint, which was filled with resin and then squeezed with an improvised rig


Total work time to date: 484 hours

2 comments:

  1. è sorprendente come la fibra, una volta intrisa di resina riesca a far risaltare le venature del legno...
    Per curiosità, quante mani di resina applichi prima di far scomparire del tutto la trama del tessuto?

    ReplyDelete
    Replies
    1. Ciao Enrico. L'effetto e' praticamente immediato: io uso una spatola per le grandi superfici ed un rullo (stavolta di spugna) per bagnare zone piu' difficili da raggiungere. Questo e' un tessuto abbastanza leggero e le venature si vedono bene anche sotto due strati di fibra. In pratica e' una sola mano, anche se ripasso spesso sulla superficie col il rullo per uniformare la distribuzione della resina. Considera che l'intera fiancata ha richiesto poco piu' di un'ora, preparando tre o quattro"batch" di resina in sequenza.

      Delete